Brake
Hold Module
Keeps Your Brake
Lights On When You Are Stopped Or Stopping So You Don’t Have To!
**Your Bike
MUST have Electronic Pick-Up Sensor**
The Brake Hold Module connects to your
bike’s electronic speed pick-up sensor (will not work with cable driven
speedometers); to keep your brake lights on when you release your brakes but are
still decelerating. In addition, it will turn them on or keep them on when you
are are stopped, even if you take your hands and feet off the brakes!
User Selected
Mode One:
Emit a visual signal of 3 short light flashes, followed by 1 long light
flash (3.5 seconds). The signal automatically repeats itself as long as the
brake lights are on. This pattern is not random, but has been selected because
of its ability to retain following drivers attention.
User Selected Mode Two:
Emit a visual signal of 5 quick flashes, followed
by a steady on light that remains steady as long as the brake lights are on.
Brake Alert:
If the Brake Hold Module is holding your brake
lights on for you and you wish to gain the attention of someone behind you;
simply press either brake and your brake lights will flash 5 times then return
to steady on.
Features:
**Your Bike MUST have
Electronic Pick-Up Sensor**
Easy Installation. -
Simply install the Brake-Hold
Module™ in line with the wire leading to the brake light, connect to a switched
power source and ground wire, and tap a wire into your bike’s speed sensor.
Large power capacity: -
12 volts DC, Maximum Capacity 10 Amps!
Compact size. - 2-1/4"L x 1-5/8"W x 5/8"H
Sealed Weather Resistant
heat sink case.
Limited Warranty - One
Year!
