Thanks for stopping by Custom Dynamics®. Sit back, relax
and take your time there's a great deal to see!

 

V-Twin, Chopper, Sportbike, Metric Cruiser, Boats, and Trucks, there's literally EVERYTHING To Light Up Your Ride!®

 

 Thanksgiving Special:  Free UPS Ground Shipping On Orders Over $50 (U.S. Only)

 

CAUTION:  PLEASE READ BEFORE REMOVING RED INSERTS!

Removing inserts is intended for OFF-ROAD, COMPETITION, AND SHOW USE ONLY

These tail lights have been designed to comply with all DOT (FMVSS Sec. 108) standards.   Removing the inserts will nullify these requirements.  Check with your local and state law enforcement for lighting requirements before proceeding. Clear Alternatives & Custom Dynamics® are not responsible for any misuse of our products.  Altering these tail lights will also void all warranties.
 
 
 

1.  Place complete unit in hot water for approximately 5 minutes. This procedure will help soften the bead of sealant used to adhere the lens to the base.
 

2.  Carefully lift the securing tabs with a flat head screwdriver.  Work slowly around the complete lens when prying the lens from the base. 

3A.  Remove inserts with a phillips head screwdriver.

   3B. If Leds are to be installed, place LED on reflector and secure with clear epoxy. Route pigtail through openings.

 

4.  Re-attach lens to the base. Use a silicone base sealant or hot glue gun to help adhere the lens. 

 

 

NOTE:  You must use red bulbs, our 1.85" pigtail LED Clusters, when you remove the inserts. 

 
Acceptance Mark
Credit Card Processing
 
 
  
Copyright Notice:  Copyright © 2003-2009 Custom Dynamics® LLC. All rights reserved.
The images and other content contained in this web site are the property of and copyrighted by Custom Dynamics® LLC. Downloading of images for personal use only is permitted. Downloading of images or text for commercial use without the written consent of Custom Dynamics® LLC is strictly forbidden. Custom Dynamics® and the Custom Dynamics® logo are registered trademarks of Custom Dynamics® LLC