Installation Instructions

Street Magic Billet Front Axle Spikes

Dress up your M109 with our New Street Magic Billet Front Axle Spikes. Made from T6061 billet aluminum with a show chrome finish.
 

Street Magic Billet Rear Axle Spikes

Dress up your M109 with our New Street Magic Billet Rear Axle Spikes. Made from T6061 billet aluminum with a show chrome finish.
 

Street Magic Billet Fork Cap Set

Dress up your M109 with our New Street Magic Billet Fork Cap Set. Made from T6061 billet aluminum with a show chrome finish.
 

Street Magic® M109 Rear LED Array Turn Signals

Rear LED Turn Signal/Brake Light Kits

by Raw Design

Replace the stock turn signal with this clean under-tail unit. Available with Turn signals only or with Center Brake Light and Side Signal lights.

 

Available styles:
RED TUBE, RED LEDS, Signals
SMOKED TUBE, RED LEDS, Signals
CLEAR TUBE, RED LEDS, Signals
CLEAR TUBE, AMBER LEDS, Signals
SMOKED TUBE, AMBER LEDS, Signals
CLEAR TUBE, AMBER SIGNALS, RED BRAKE
SMOKED TUBE, AMBER SIGNALS, RED BRAKE

 

Clean up the look of your 109 with this Custom Signal kit. These SUPER BRIGHT LEDs replace the stock lollipops and installs within minutes using existing mounts and hardware. Please note, the use of a Load Equalizer (sold separately), will be required to maintain the stock flash rate.

  LEDs have a 120 Degree Viewing Angle

Please note: These products are not DOT approved. Use at your own risk, we are not responsible for any damages or losses incurred while using our products.

Use of these products may be limited, regulated or prohibited in your state, please check all applicable motor vehicle code and laws before ordering.

 

M109 Rear Blinker Instructions

Eclipze Module 

 

 (Click on Eclipze Logo for More Information)

M-109 "FlatZ" Signal Lights

"FlatZ" are another way to distinguish your M-109 and deliver looks and safety in the same package.

They beautifully match the swept lines of the bike and can be used for Front AND Rear signals for a complete matched and custom look. Built-in "wing" lights add visibility to your sides that are better than stock signals. Made from aircraft grade aluminum and Triple Show Chrome plated for a brilliant finish.
 
Sold in Pairs
 

"BullitZ" Signal Lights

RAW Design "BullitZ" lights will fit any bike with a 7/16" mounting hole. The angled mount offers several "looks" for both the Front and Rear signals while improving side lighting for higher visibility in traffic.
Made from Aircraft Grade Aluminum and Show-Chrome plated for a brilliant finish.

Sold in Pairs
 

M109 C.A. Front Signal / Running lights

by Raw Design

Eliminates "Lollipops" and extremely bright
3 Rows of the brightest LED's available make these Signal / Running lights highly visible from front or side. Easily mounts using existing headlight location and fasteners. Start to finish installation time of less than 1 hour!
 

2 Position License Plate

Now you can have either style with the same unit at any time you like. Just pivot the plate mount along it's center hinge point and it is held in place by super-strong magnets., show chrome plated.

Available for Suzuki M109, Suzuki Marauder, Suzuki GSXR, Honda VTX 1800, & Honda Valkary

Plate Frame Sold Separately
 

M109 Scorpion Exhaust Pipe Tips, Hook Cut

Absolutely the best Bang-For-Buck modification you can make to your bike! Looks great and sounds even better while keeping the stock ECU and emissions equipment.

These are Triple chrome plated and can be adjusted to face up, down or anywhere in between to give it your own style. Good sound at cruise...sounds like a NASCAR under acceleration at higher RPM's. A common increase of 6 H.P. gain and 3Lbs. torque.
 

Click on the You Tube link below to see and hear dyno runs:

http://www.youtube.com/watch?v=jmKWxi2v4GE
 

M109 Exhaust Tip Installation Instructions

"Shotgun" Pipe Tips

Add a Custom Pipe and Deep Throated sound without the custom cost and exhaust issues of complete systems. Triple Show Chrome plated and guaranteed not to blue. (Shown with optional "Choker" end caps. See additional photos for standard Shotgun.)

Choker Caps option available as separate item below.

Suzuki spent BIG bucks to design an exhaust system that works with the 109. Why completely change it? Shotgun Tips install just like our very popular Scorpion Tips and leave all the stock ECU and catalytic converter items in place, all at a fraction of the cost of complete exhaust systems. No reprogramming or aftermarket controller is necessary. Shotguns contain no baffle. They add a cool rumble under most circumstances but SCREAM when you hit the throttle!

"Choker" End Caps for Shotgun Pipe Tips

Add Chokers for a different look. Adds some back-pressure and more of a "POP" to the exhaust note.

Black anodized and machines from Billet Aluminum.

Stealth LED License Kit - Suzuki M109

by

Show off that Phat rear tire and clean up the rear of your M109 with this one great Baron Product.  Dynamic LED lighting recessed into this compact chrome frame provides bright night-time illumination for your license. Integrated one-piece hidden mounting platform replaces the bulky, ugly black plastic license mount assembly - quickly and easily. Streamlined recessed mounts allow you to use custom indicator lights like our Bullet Marker Lights or you can reuse your stock turn signals as shown.
 

Made from 6061 T6 Billet Aluminum with a Black Hardcoat Anodized Finish For Years of Trouble Free  Service