Auxiliary LED Light Bar with Sequential Running & Flashing Brake Alert

LB02
$29.95  Each
$29.95  Each
Shipping calculated at checkout.

Verify Your Fitment

Fitment for U.S. models only, unless otherwise noted.

This fits your vehicle!
( CHANGE VEHICLE )
Click here to find fitting parts.
This does not fit your vehicle.
( CHANGE VEHICLE )
Click here to find fitting parts.

Question about this product?

We're happy to help.

Dual intensity light bar with Red LEDs. In running light mode the LEDs sequence from side to side in a "Knight Rider" sequence. When the brake is applied the LED will flash for approximately 5-6 seconds then go to a solid on state until the brake is released. Both modes, running and brake, have been designed to create the maximum visibility. The unit comes pre-taped with 3M™ double sided tape for easy mounting to any flat surface. Simply connect the black wire to any ground wire, the Red wire to your existing brake light wire and the blue wire to an existing running light power source. No load equalizer or resistors required.

Warning: Cancer & Reproductive Harm — www.p65warnings.ca.gov

Fitment

Works with any 12VDC system

Specifications

  • DUAL INTENSITY, RED LEDS
  • SEQUENTIAL RUNNING LIGHT WITH FLASHING BRAKE ALERT
  • CHOICE OF RED OR SMOKE LENS
  • DIMENSIONS: 0.7" W X 0.7" H
  • 24 GAUGE 45” WIRE LEAD
  • 12 LED KNIGHT RIDER 4.7" L
  • 21 LED KNIGHT RIDER 7.5" L
  • LIFETIME LED WARRANTY
  • SOLD EACH

Instructions

Compatible Fitment
This part fits the following vehicles:
Type Year Make Model
Loading fitment data...
  • 5 stars: 6 (100%)
  • 4 stars: 0 (0%)
  • 3 stars: 0 (0%)
  • 2 stars: 0 (0%)
  • 1 star: 0 (0%)
A
Anonymous

Naturally had to rewire some things but they add a neat visible attention to the rear.

A
Anonymous

Repeat customer. Always satisfied!

K
Knight rider LED
Great Product

This product is great. Does what it’s suppose to do. Good quality. Everything works. Wires are a bit small so don’t expect wire nuts to work. All and all good product. NOW, here was my issue. The wires that come out of this light, are directly in the middle of it. Not the side, not the bottom. Right in the middle. So that leaves the question, well how am I going to get this thing to stick on a flat surface if the wires are in the way. So, that being said unless you are planning to drill a hole for the wires to pass through whatever you are sticking it on, just be cautious. I fabricated a whole piece so I didn’t have to drill through my rear fender. OTHER THAN THAT, good product, bright and flashes well.

p
pcj
lighting

product is great and adds a bit of safety

J
John Studley
Video

I agree with the other review. A video is needed.

t
thaied
why not have a video to show this

sounds great and sure would like to see the scrolling lights to brake lites in a video